🔊
SpinCAD Designer
  • Welcome to SpinCAD Designer!
  • Tutorials
    • Getting Started
    • The User Interface
    • Creating a patch
  • Menus
    • File
    • Edit
    • Loop
  • Blocks
    • I/O Mix
    • Wave Shaper
    • Dynamics
      • RMS Lim/Exp
    • Controls
      • Introduction to control signals and blocks
      • Two-stage
      • Invert, Power, Two-Stage, and Vee
      • Ratio
      • Scale/Offset
      • Clip and Tremolizer
      • Envelope
      • Slicer and Smoother
      • Tap Tempo
    • Pitch
      • The Pitch Offset Blocks
  • Design Concepts
    • Basic LFOs in SpinCAD Designer
    • Deep dive into the Three-Tap Delay block
      • Deep dive into the ThreeTap Delay, part 1
      • Deep dive into the ThreeTap delay, part 2
      • Deep dive into the ThreeTap Delay, part 3
    • Analyzing the Spin auto-wah peak detector
      • The Spin auto-wah peak detector, part I
      • The Spin auto-wah peak detector, part II
      • The Spin auto-wah peak detector, part III
    • Intro to the "Dattorro" reverb structure
    • Analyzing the Spin Mini Reverb
      • Analyzing the Spin "Mini Reverb" part 1
      • Analyzing the Spin "Mini Reverb" part 2
      • Analyzing the Spin "Mini Reverb" part 3
  • Patches
    • Making a tremolo patch
    • Making a vibrato/chorus patch
    • Making a pitch shifting delay
    • Multi-head "drum/tape" delay
    • 4-phase LFO driven mixer
  • Tips and Tricks
    • Editing tips for fast patch creation
    • Programming the FV-1 EEPROM with your code
    • Optimizing FV-1 assembly code generated by SpinCAD Designer
  • Beneath the Hood
    • How SpinCAD Builder works
    • Analyzing a simple SpinCAD Builder file
Powered by GitBook
On this page
  1. Design Concepts

Analyzing the Spin Mini Reverb

Analyzing the Spin "Mini Reverb" part 1Analyzing the Spin "Mini Reverb" part 2Analyzing the Spin "Mini Reverb" part 3
PreviousIntro to the "Dattorro" reverb structureNextAnalyzing the Spin "Mini Reverb" part 1

Last updated 2 years ago